35
INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
Changing the audio source
You can change the audio source at any time during navigation.
1 Press the TUNE A or CD.C @ button during an active navigation ses-
sion.
✔ The main menu for radio mode or CD changer mode opens. CD changer
mode is only available if a CD changer is connected and operational. It is
not possible to play a CD in the internal CD drive during a navigation
session.
2 Now, for instance, you can select another station or another track.
If you want to switch back to the navigation session display,
3 press the NAV button ?.
Cancelling navigation
To cancel an active navigation session,
1 press the ESC button <
or
1 enter a new destination
or
1 switch to position tracking mode (see “Position tracking mode” in this
chapter).
✔ If you pressed the ESC button <, the system asks you to confirm your
choice.
If you are sure you want to cancel navigation,
4 select YES and
5 press the OK button 8.
TIP: If you switch the unit off whilst navigation is active, the data for that
navigation session will be stored for 30 minutes. You can continue navi-
gation at any time within this time period (e.g. after stopping for petrol).
Note: If you remove the navigation CD during a navigation session,
NO MAP navigation will be activated.
NAVIGATION
TO INTERRUPT
ROUTE GUIDANCE?
DO YOU WANT
YES NO
Confirmation request before cancelling navigation
To Next Page
Loading...
