EasyManua.ls Logo

Blaupunkt Woodstock DAB 53 - Page 34

Blaupunkt Woodstock DAB 53
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DANSK
77
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
case, format the MMC/SD using a suit-
able MMC/SD read/write device con-
nected to your PC or in your car audio
system. We recommend you carry out
formatting operations using the car au-
dio system. For further details on this,
please refer to the section entitled “For-
matting MMCs/SDs” in this chapter.
Blaupunkt cannot guarantee the correct
functioning of all MMCs/SDs due to the
large number of MMCs/SDs available
on the market and the varying quality
standards applied by manufacturers.
The recording function provided by the
Woodstock DAB53 was tested using
MMCs/SDs with capacities up to
256 MB manufactured by “Sandisk”
(www.sandisk.com).
Blaupunkt recommends Sandisk
MMCs/SDs up to 256 MB for re-
cording using the Woodstock
DAB 53.
If you want to use a read/write de-
vice for formatting and editing
MMCs/SDs, we recommend you
use read/write devices manufac-
tured by
Sandisk (www.sandisk.com),
Retec (www.retec-gmbh.de) or
Dazzle (www.dazzle.de).
Starting recording
To store a DAB programme on an MMC/
SD,
switch to DAB mode and select the
programme that you want to
record. For further details, read the
chapter entitled “DAB mode”.
Press the OK button ; when you
want to start recording.
Notes:
To avoid damaging the MMC/SD,
you should never start the engine
whilst recording. Starting the en-
gine might cause the voltage of the
vehicle’s electrical system to drop,
which could permanently damage
the MMC/SD.
The automatic DAB-FM switching
feature is deactivated whilst record-
ing is taking place. The DAB pro-
gramme remains tuned during re-
cording, even if the reception quali-
ty deteriorates.
Recording starts, “RECORDING” ap-
pears for 2 seconds in the display, and
then an “R” appears in front of the pro-
gramme name for the duration of the
recording.
If there is not sufficient space available
on the card, “CARD FULL” is displayed
for 2 seconds in the display. If this is the
case, delete some tracks from the MMC/
SD (see “Deleting recordings” below) or
insert another MMC/SD.
The file created during recording is
given a name as follows:
ddhhmmss.mp3. “dd” stands for the
day the recording was made, “hh
stands for the hour recording was start-
ed, “mm” stands for minutes and “ss
for seconds.
The device creates the “DAB_DIR” di-
rectory on the MMC/SD for the record-
ed files.
MMC/SD MODE

Table of Contents

Related product manuals