Blendtec Professional Series - NEVER OPERATE THE BLENDER USING ATTACHMENTS NOT SOLD BY BLENDTEC; CONTAINER MUST BE PROPERLY IN PLACE WHILE APPLIANCE IS OPERATING; BLADES ARE SHARP! HANDLE CAREFULLY!; WHEN BLENDING HOT LIQUIDS, REMOVE CENTER PIECE OF LID

CN-2
1.8NEVEROPERATETHEBLENDERUSINGATTACHMENTSNOTSOLDBY
BLENDTEC
The use of any unauthorized attachments may cause re, electric shock, and/or injury
and will void the warranty.
1.9CONTAINERMUSTBEPROPERLYINPLACEWHILEAPPLIANCEIS
OPERATING
1.10BLADESARESHARP!HANDLECAREFULLY!
1.11WHENBLENDINGHOTLIQUIDS,REMOVECENTERPIECEOFLID
1.12POWERCORDPRECAUTIONS
• NEVER operate with a damaged cord or plug. (If the supply cord is damaged it
must be replaced by the manufacturer, or authorized service agent to avoid a
hazard
• DO NOT permit the cord to hang over the edge of the work surface.
• NEVER use an extension cord with the unit.
• Unplug the blender motor when not in use; before changing blender locations; or
cleaning.
1.13NEVERATTEMPTTOREPAIRTHEPOWERUNIT
Never remove the blender motor cover. The blender motor does not contain self-
adjustable or serviceable parts. A qualied service agent must make all service
adjustments. Removing the cover or attempting to service the blender will void the
warranty.
1.14TURNTHEPOWERSWITCHOFFWHENNOTINUSE
The Power Switch (ON/OFF switch) is located on the front panel of the blender motor
cover.
1.15AVOIDTOUCHINGTHEBLENDERDRIVESOCKETAFTER EXTENSIVE
USE.
The blender drive socket may become hot after numerous cycles.
1.16CLOSESUPERVISIONISNECESSARYWHENAPPLIANCEISUSEDBY
ORNEARCHILDREN.
1.17THECONNOISSEURISINTENDEDFORHOMEUSEONLY!ANYUSEOF
THECONNOISSEURFORCOMMERCIALPURPOSESVOIDSALLWARRAN-
TIES.
SAVETHESEINSTRUCTIONS