Blendtec Professional Series - INSTALLATION; CONNOISSEUR ABOVE COUNTER INSTALLATION

CN-6
SECTION4
INSTALLATION
It is recommended that surge protection be placed between the receptacle and the
blender motor.
4.1CONNOISSEURABOVECOUNTERINSTALLATION
1. Place motor into base unit.
2. Place blender on a at, clean and dry surface.
3. Make sure a plug outlet is available within four feet of the blender motor.
4. Ensure that the unit is turned off before plugging it into a separate 120-volt recep-
tacle.
5. Ensure that blender vents are unobstructed to allow proper cooling during use.







