0 No action When the same command is repeated the no action
should be sent between the commands to make it
possible for the instrument to detect new commands.
1 Start operation When the instrument is in ‘Wait for start state’, this
command can be used to start up the instrument.
2 Enter Remote operation This command disables the keys on the instrument.
This means that an external computer is controlling the
instrument or the instrument is controlled using digital
inputs.
3 Exit Remote operation This command enables the keys and leaves the remote
operation.
10 Auto tare Perform a tare operation
11 Set scale to zero Zero the gross weight
12 Select gross mode Switch to gross mode (display)
13 Select net mode Switch to net mode (display)
14 Weight display Switch from flow to weight display
15 Flow rate display Switch from weight to flow display
16 Print command Initiate a print output
100 Activate setpoint 1 Activate the setpoint
101 Deactivate setpoint 1 Deactivate the setpoint
102 Activate setpoint 2
103 Deactivate setpoint 2
104 Activate setpoint 3
105 Deactivate setpoint 3
106 Activate setpoint 4
107 Deactivate setpoint 4
132 Activate setpoints 1 - 4 Activates all 4 setpoints
133 Deactivate setpoints 1 - 4 Deactivates all 4 setpoints
200 Set Analog output Remote control of analog output. Set actual current or
voltage output value.
201 Set digital outputs Remote control of digital outputs. Set or reset the 4
outputs.
220 Set Preset Tare value Set Preset Tare to desired value.
221 Set Level value Set selected Level to desired value.
222 Set Setpoint value Set selected Setpoint to desired value.
223 Clear Acc. Weight Set accumulated weight to zero.
252 Clear Program reset bit Clear the Program reset bit in the Instrument Status
register. Set at power up.
To Next Page
Loading...
