Blomberg BGRP34520CSS - Preventing Tip-Over Hazards; Anti-Tip Stability Device Installation

cabinets or a 24-inch minimum when bottom of
wood or metal cabinets are protected by not less
than a 1/4-inch flame retardant millboard cov-
ered with not less than no. 29 msg sheet-steel,
0.015-inch stainless steel, 0.024-inch aluminum
or 0.020-inch copper.
To eliminate the risk of burns or fire by reaching
over heated surface units, cabinet storage space
located above the surface units should be
avoided. If cabinet storage is to be provided, the
risk can be reduced by installing a range hood
that projects horizontally a minimum of 5 inches
beyond the bottom of the cabinets.
This appliance is not intended for use in mobile
homes, recreational vehicles.
& Important notes to the installer
Read manual before installing the cooker.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the
consumer.
Be sure your range is installed and grounded
properly by a qualified installer or service techni-
cian.
IMPORTANT:
Before installing the range in an area covered
1---with linoleum or any other synthetic floor
covering, make sure the floor covering can
withstand heat at least 90°F (32.2°C) above
room temperature without shrinking, warping
or discoloring.
Do not install the range over carpeting unless you
place an insulating pad or sheet of l/44nch
(0.64cm) thick plywood between the unit and
carpeting.
m~~~~!~~~n tip and injury to persons could
·· result.
• Anti-Tip stability devices are fixed on
wooden plate. During the removing packaging
materials, the Anti-Tip stability devices should
be unscrewed from wooden plate and should
not be thrown away.
• A risk of tip-over may exist if the appliance
is not installed in accordance with these
instructions.
• If the range is pulled away from the wall for
cleaning, service or any other reason, ensure
that the Anti- Tip Device is properly re-
engaged when the range is pushed back
against the wall. In the event of abnormal
usage (such as a person standing, sitting or
leaning on an open door), failure to take this
precaution can result in tipping of the range.
Personal injury might result from spilled hot
liquids or from the range itself.
Anti- Tip stability device installation instruc-
tions
1 . Fix the bracket 1 to the ftoor with 4 screws (5)
in accordance with the dimensions and direction
indicated in Picture 1.
2. Measure dimension A of the product indicated
in Picture 2 according the height of counter.
Decide the hole on bracket 1 to which the
bracket 2 will be secured. Complete the
installation by tightening parts 3 and 4.
3. Position the appliance on its place after
completing the installation.
4. Check whether the appliance is locked with
bracket by gently lifting it up from rear side to
front side.
17/EN