Blomberg BGRP34520CSS - Connecting to the Gas Supply; Gas Supply Connection Standards and Requirements; Massachusetts Gas Installation Rules; Flexible Connector Gas Method

mWARNING: Tip Over Hazard
r . tA child or adult can tip the range and be
•·· killed. Connect anti-tip bracket to anti-tip hole
at the back of the range. Reconnect the anti-
tip bracket, if the range is moved. Failure to
follow these instructions can result in death or
serious burns to children and adults.
ARNING: Electrical shock hazard!
• Use extreme caution when drilling holes into
1'-...:;..~•·the wall or floor. There may be concealed
electrical wires located behind the wall or
under the floor.
• Identify the electrical circuits that could be
affected by the installation of the Anti Tip
Device, then turn off power to these circuits.
Failure to follow these instructions may
result in electrical shock or other personal
injury.
Connection to the gas supply
This appliance has been tested in accordance
with the following standards:
• ANS Z21 .1 b-2012 Household Cooking
Appliances
• It is the responsibility of the owner and the
installer to determine if additional require·
ments, such as local codes and/or stan-
dards, apply to specific installations. In the
absence of local codes, the installation must
conform with the National Fuel Code, ANSI
Z223. ·1 /NFPA54.
For Massachusetts Installations:
1 . Installation must be performed by a qualified
or licensed contractor, plumber or gas fitter
qualified or licensed by the state , province or
region where this appliance is being installed.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer
than 36 inches.
Installer -show the owner where the gas shut-off
valve is located.
High Altitude Installation note:
This cooker is ETL certified for safe operation up
to an altitude of 2.000 ft. without any modifica-
tions. For higher altitudes, please contact with
Service.
Connect to the gas supply
ARNING:
product can be converted to LP
Gas convertion must always be
performed by Authorized Service Agents.
The gas connection is located below the back
panel of the range. It is accessible back of the
range.
Shut off main gas supply valve before discon-
necting the old range and leave it off until the
new hook-up has been completed.
The cooker can be installed using rigid pipe or a
GSA, cCSAus, UL International-certified flexible
rnetal appliance connector. If using a flexible
connector, always use a new connector.
Apply pipe joint corn pound or tape appropriate
for use with Natural gas around all rnale pipe
threads to prevent leaks.
If not already present, install gas shut off valve in
an easily accessible location. Make sure all users
know where and how to shut off the gas supply
to the range.
Gas supply pressure for checking the regulator
setting is 6" we.
··rnNOTICE:
•• I he installer should inform the consumer of
•• he location of the gas shut-off valve. Flexible
Connector Method
1 . Install rnale 1 /2" flare adaptor at the 1 /2" NPT
internal thread of the range inlet. Use a backup
wrench on the elbow fitting to avoid darnage.
2. Install rnale 1/2" or 3/4" flare union adapter
on the NPT internal thread. of the rnanual shut-
off valve.
3. Connect flexible rnetal appliance connector.
4. Make sure circuit breaker is off and then plug
range cord in to electrical outlet
5. Push range back into position insuring that
range leg slides under the anti-tip bracket. The
range will sit 3/4" away frorn the wall when
properly installed.
19/EN