Need help?Do you have a question about the Blue Yeti and is the answer not in the manual?
Three condenser capsules in an innovative configuration for great recordings in most situations.
Select from Yeti's four pattern settings (stereo, cardioid, omnidirectional, bidirectional) by rotating the pattern selector knob.
Controls the gain (sensitivity) of Yeti's microphone elements. Adjust for loud or quiet sound sources.
Indicates the front of the microphone.
Tighten to secure the microphone at the desired angle. Unscrew to remove from the desk stand.
Mount Yeti to a studio mount by removing from desk stand and threading in a standard mount.
Captures a realistic stereo image, picking up equal signal from left and right channels when centered.
Picks up sound directly in front, rejecting sound from rear and sides, ideal for vocals and podcasts.
Picks up sound equally from all directions, perfect for group recordings or capturing room ambience.
Picks up sound from front and rear, rejecting sides, useful for interviews with two or more guests.
Details on power, sample rate, bit rate, capsules, polar patterns, frequency response, and sensitivity.
Details on impedance, power output (RMS), and THD for the headphone amplifier.
Includes frequency response, signal to noise ratio, dimensions, and weight.
Lists required PC and Macintosh operating systems, USB versions, and RAM.
General| Transducer Type | Condenser |
|---|---|
| Polar Patterns | Cardioid, Bidirectional, Omnidirectional, Stereo |
| Frequency Response | 20Hz - 20kHz |
| Sample Rate | 48kHz |
| Bit Rate | 16-bit |
| Connection Type | USB |
| Headphone Output | Yes |
| Impedance | 16 Ohms |
| Sensitivity | 4.5mV/Pa (1 kHz) |
| Max SPL | 120dB |
| Dimensions | 12cm x 12.5cm x 29.5cm |
To Next Page
