BLUM AVENTOS HL Installation

11
5 Technical data
5.1 Power supply
Input voltage: 100-240VAC / 50-60Hz
Input voltage Japan: 100VAC ±10% / 50 and 60Hz
Output voltage: 24VDC
Nominal output current: 3.0A (Z10NE010.xx)
4.17A (Z10NE050.xx)
Operating temperature: 0 to +40°C
Protection category: IP40
Should only be used in dry, enclosed rooms
5.2 Drive unit
Supply voltage: 24VDC
Rated current: 1.4A
Power consumption in standby mode: 0.6W (front closed)
Operating temperature: 0 to +40°C
Protection category: IP20
Should only be used in dry, enclosed rooms
5.3 Blum switch
Frequency: 2.4GHz
Transmission method: Bidirectional, via a coded wire
Range: typically 10m (depending on material
and contents)
Operating temperature: 0 to +40°C
Protection category: IP20
Battery supply: 3V Lithium button cell CR2032
Should only be used in dry, enclosed rooms
6 Replacement parts
⇒ Spare parts can be ordered from your distributor or furniture supplier.
7 Disposal
SERVO-DRIVE for AVENTOS removal may only be carried out by qualified person-
nel according to the separate installation instructions.
All SERVO-DRIVE for AVENTOS electronic components, including the battery,
should be disposed of in a separate collection for electrical appliances as per local
regulations.

BLUM AVENTOS HL Specifications

General

Category	Lift system
Cabinet width range	Up to 1800 mm
BLUMOTION	Yes
SERVO-DRIVE	Optional
Application	Lift system for wall cabinets
Cabinet height range	300 mm to 580 mm
Motion technology	BLUMOTION
Material	Steel
Adjustment	3-dimensional adjustment
Opening Angle Stop	Optional
Mounting	Screw-on system