BLUM MINIPRESS User Manual

39
K
Troubleshooting - What to do, if ...?
Fault during drilling
Fault Cause of fault Eliminating fault Remarks
•Drilled holes are
off-center or hole
position is incorrect
•Pneumatic brake is
set too tight
•The fence stops are
set wrong
•Ruler incorrectly set
•Wood chips are
between the fence
and the fence
supports
•Fencing System
incorrectly set
•The fence extension
is not installed
properly
•Gear box does not
engage
•Location pin does not
engage into the
locating plate
• Slightly open the
throttle valve
• Check position of
fence stops and
adjust if necessary
• Adjust ruler
• Remove wood chips
and dirt from fence
support
• Check setting and if
necessary rectify
• Check fence
extension and fence
extension supports
• Check the distance
between the rulers
• Allow fixing pin for
drill head to engage
• Check position of
the location pin
See chapter F
No comments
No comments
No comments
See chapter F
No comments
No comments
See chapter F
See chapter
D and G
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English