BLUM MINIPRESS User Manual

40
K
Troubleshooting - What to do, if ...?
Fault during drilling
Fault Cause of fault Eliminating fault Remarks
•Drilled holes too
large, oval or
ragged
•Drill bits get stuck
in the panel
•Drill bit diameter too
large
•Drill bit is bent
•Drills bits are dull
•Stroke speed too
high for drilling
•The panel was drilled
through completely
•Gearbox shafts are
bent
•Panel material other
than stated in the
intended use of this
machine was used
•Down stroke speed
during drilling is too
fast
•The clutch is
damaged (the drill
bits get jammed in
the workpiece while
the motor fan keeps
on rotating)
• Check drill bit
diameter
• Replace drill bit
• Regrind or replace
drill bit
• Adjust stroke speed
• Adjust drilling depth
• Replace gearbox
• Only panels of
wood, particle board
or laminated particle
board are to be used
• Adjust down stroke
brake properly
• Replace defective
clutch
No comments
No comments
No comments
See chapter F
No comments
No comments
No comments
See chapter F
See chapter I
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English