WEIGHTING AND COUNTERWEIGHTING
28
The BMC LD6 and MD8 Series Backhoes are not to be used without a front loader or front blade which will lift front
wheels.
NOTE: Use hand signals shown on page 40 when operator is taking directions from others.
OPERATION
Do not use the LD6 or MD8 Series Backhoe as a personal hoist, for lifting or conveying personnel on the
bucket or boom, or providing a work platform for personnel.
Never attempt to drive the tractor when seated at the Backhoe controls.
Operate the Backhoe Controls only when seated at the controls. Any other method could result in serious
injury.
Proper operation of the backhoe controls will produce a smooth digging motion. Observe the following points to
obtain the best results and to fully utilize the digging forces with the least amount of stress and strain on the
backhoe and tractor. Practice will make you a proficient operator.
Set the stabilizers to remove as much weight from rear wheels. The Loader Bucket should also be on the ground to
stabilize the front of the tractor.
PLACING THE STABILIZERS
To Next Page
Loading...