42
SWITCH
The Switch is an optional wall switch available in three types of configurations
to suit your RV. The Switch communicates by Bluetooth to the Node to provide
additional control of RV features and accessories.
REPLACING THE BATTERY IN YOUR SWITCH
The Switch is powered by a standard, 3V Lithium Cell coin battery (CR2032).You
can check if the battery needs replacing from the RVMaster App General Settings.
Open the BLE Wall Switches settings, then press any button on the switch whose
battery you are checking. The RVMaster App will refresh with the switch battery
status.
To replace the battery, unclip the Switch button pad.
You may need a flathead screwdriver or similar to pry open the Switch button pad,
and to remove the battery from the battery holder.
Insert the new battery in the battery holder with the positive side facing up.
Any Switch you install in your RV has been paired to the Node at the factory and is
ready for immediate use.
To Next Page
Loading...