Warning
Due to high speeds when PDC Park Distance
Control is activated, the warning can be de‐
layed due to physical circumstances. There is a
risk of injury or risk of damage to property.
Avoid approaching an object too fast. Avoid
driving off fast while PDC Park Distance Control
is not yet active.
Overview
Button in the vehicle
Park assistance button
Sensors
The system is controlled by the following sen‐
sors:
▷ Ultrasound sensors in the front/rear bumpers.
▷ Depending on the equipment: ultrasonic sen‐
sors on the side.
Additional information:
Sensors of the vehicle, refer to page 35.
Switching on/off
Switching on automatically
The system switches on automatically in the fol‐
lowing situations:
▷ If selector lever position R is engaged when
the engine is running.
▷ Depending on the equipment version: while
approaching detected obstacles at a speed
slower than approx. 2.5 mph/4 km/h. The ac‐
tivation distance depends on the situation in
question.
You may switch automatic activation when ob‐
stacles are detected on and off.
1. "CAR"
2. "Settings"
3. "Driver Assistance"
4. "Parking and Maneuvering"
5. If necessary, "Automatic PDC Activation"
6. "Automatic PDC Activation"
Depending on equipment, an additional camera
view is also switched on.
Automatic deactivation during
forward travel
The system switches off when a certain driving
distance or speed is exceeded.
Switch the system back on, if needed.
Switching on/off manually
Press the park assistance button.
▷ On: the LED lights up.
▷ Off: the LED goes out.
The rearview camera image is displayed if the re‐
verse gear is engaged when pressing the park
assistance button.
Depending on the equipment version, the sys‐
tem cannot be switched off manually if the re‐
verse gear is engaged.
Warning
Signal tones
General information
An intermittent tone indicates when the vehicle
is approaching an object. E.g., when an object is
Seite 240
CONTROLS
Driver assistance systems
240
Online Edition for Part no. 01405A2C7F8 - II/21
To Next Page