Vehicle Interface of Integrated Communication Optical Module (ICOM)
Page 6
User Guide
of 29
Copyright © BMW AG / ICOM User Guide
Version 1.0/ Februar 08
3.2
Information regarding handling, storage and transport
Detailed knowledge and technically correct implementation of the safety instructions and
functions described in this user's guide are a precondition for operational safety.
• The safety of the product presupposes proper and adequate transport,
storage, installation and operation.
• The devices may only be commissioned by qualified personnel who are
familiar with the contents of this user's guide.
• The devices are only to be used for the permitted purpose on the vehicle.
If the handling regulations and technical safety instructions are complied with, the product is
normally not a source of danger with regard to property damage or personal injury.
For the use case, the following must be observed:
• National safety regulations
• National accident prevention regulations
• Generally recognized rules of engineering
• Safety instructions in this user's guide
• Specified operation conditions of the devices
• Additional instruction plates on the device.
• Only the software intended by the manufacturer for the
application case is to be used.
For handling, the following must be observed:
• The devices must not be exposed to direct sunlight.
• Avoid splashing fluids (water, acid, solvent etc.).
• Do not expose the devices to extreme mechanical stresses (e.g.
dropping from high heights).
• Only the cables described in this user's guide are to be used for operation.
• Before commissioning, check whether a device or cable shows any signs of
mechanical damage. Should this be the case, it is no longer permitted to use
the device or cable concerned.
• Additional instruction plates on the device.
• No unauthorized interventions on the devices are permitted.
• Before and after use, the devices - including accessories - are to be placed
in storage in such a way that there is no danger of injury or damage.
To Next Page
