BMW R 1200GS 2016 User Manual

General instructions
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Further information about main-
tenance and repair work can be
obtained on DVD through your
authorized BMW Motorrad re-
tailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work.
If you are in doubt, consult an
authorized workshop, preferably
your authorized BMW Motorrad
retailer.
Tool kit
1 Screwdriver handle
Use with screwdriver bit.
Topping up engine oil
( 133).
2 Reversible screwdriver in-
sert
Phillips PH1 and Torx T25
Remove light sources in
front and rear turn indi-
cators ( 152).
Remove battery cover
( 156).
3 Open-ended wrench
Wrench size: 8/10 mm
3 Removing battery
( 156).
4 Open-ended wrench
Wrench size: 14
Adjusting mirror arm
( 88).
Service tool kit
with service tool set
OA
For more extensive service op-
erations (such as wheel removal
and installation), BMW Motorrad
has put together a service tool kit
matched to your motorcycle. You
can purchase this tool kit from
8
130
z Maintenance

BMW R 1200GS 2016 Specifications

General

Displacement	1170 cc
Bore x Stroke	101 mm x 73 mm
Max Power	125 hp (92 kW) at 7, 750 rpm
Max Torque	125 Nm at 6, 500 rpm
Compression Ratio	12.5:1
Fuel System	Electronic intake pipe injection
Final Drive	Shaft drive
Front Tire	120/70 R 19
Rear Tire	170/60 R 17
Length	2, 210 mm
Width	953 mm
Height	1, 450 mm
Wheelbase	1, 507 mm
Fuel Capacity	20 liters
Engine Type	Air/liquid-cooled four stroke flat twin engine, double overhead camshaft, one balance shaft
Transmission	6-speed
Clutch	Hydraulically operated wet clutch
Frame	Two-section frame, front- and bolted-on rear frame
Rear Suspension	Cast aluminum single-sided swing arm with BMW Motorrad Paralever
Front Brakes	Dual 305 mm discs, 4-piston calipers
Rear Brakes	Single disc brake, diameter 276 mm, 2-piston floating caliper
ABS	BMW Motorrad ABS (partly integral)
Seat Height	850 mm
Wet Weight	244 kg