BMW R 1200GS 2016 User Manual

cated on the edge of the tire, e.g.
by the letters TI, TWI or by an
arrow.
When the minimum tread depth
is reached:
Replace the worn tires.
Checking spokes
with cross spoke wheels
OE
Park motorcycle, ensuring that
support surface is firm and
level.
Using the handle of a screw-
driver or similar object, run it
over the spokes and listen to
the sound pattern.
If the sound pattern is uneven:
Have spokes checked
by a specialist workshop,
preferably by an authorized
BMW Motorrad Retailer.
Wheels
Tire recommendation
For every size of tire,
BMW Motorrad has tested and
approved certain makes as
roadworthy. BMW Motorrad
cannot evaluate the suitability of
other tires, and can therefore
take no responsibility for their
driving safety.
BMW Motorrad recommends
only using the tires tested and
approved by BMW Motorrad.
The permissible maximum speed
and load capacity figures must
be complied with (see "Technical
Data").
Observe the notes on maximum
speed with studded or winter
tires ( 97).
Detailed information can be
obtained from your authorized
BMW Motorrad retailer or online
at:
bmw-motorrad.com
Affect of wheel sizes
on suspension control
systems
The wheel sizes play a major role
for the ABS and ASC suspension
control systems. The diameter
and width of the wheels stored
in the control unit have particular
significance as the basis for all
necessary calculations. A change
in these sizes resulting from con-
version to wheels not installed
as standard equipment can seri-
ously affect the control efficiency
of these systems.
The sensor rings required for
wheel speed detection must also
match the installed control sys-
tems and may not be replaced.
If you want to equip your
motorcycle with different wheels,
please contact a specialist
service facility, preferably a
BMW Motorrad retailer. In some
cases the data stored in the
8
141
z Maintenance

BMW R 1200GS 2016 Specifications

General

Displacement	1170 cc
Bore x Stroke	101 mm x 73 mm
Max Power	125 hp (92 kW) at 7, 750 rpm
Max Torque	125 Nm at 6, 500 rpm
Compression Ratio	12.5:1
Fuel System	Electronic intake pipe injection
Final Drive	Shaft drive
Front Tire	120/70 R 19
Rear Tire	170/60 R 17
Length	2, 210 mm
Width	953 mm
Height	1, 450 mm
Wheelbase	1, 507 mm
Fuel Capacity	20 liters
Engine Type	Air/liquid-cooled four stroke flat twin engine, double overhead camshaft, one balance shaft
Transmission	6-speed
Clutch	Hydraulically operated wet clutch
Frame	Two-section frame, front- and bolted-on rear frame
Rear Suspension	Cast aluminum single-sided swing arm with BMW Motorrad Paralever
Front Brakes	Dual 305 mm discs, 4-piston calipers
Rear Brakes	Single disc brake, diameter 276 mm, 2-piston floating caliper
ABS	BMW Motorrad ABS (partly integral)
Seat Height	850 mm
Wet Weight	244 kg