still cannot start car, please refer to the special notes 2 in Chapter 5
Method 2: In (PICTURE 6.1), select Prepare dealer key with ignition switch,
select key type and pre-process the blank key, insert to ignition switch and wait
complete. After finish, turn to step 5). If you get failure here, you need load key info
to unlock the failed key via click unlock key before try again
4) In (PICTURE 6.1), clear trouble codes with Clear DTC and Clear Shadow
5) Complete
6.5. CAS3+ encrypt version (include ISTAP)
make dealer key by OBDII
6.5.1. Add Key
Attention: For details of this process, please refer to Chapter 6.3
Specific Steps:
1) Insert a working key to car ignition and switch ON, switch on the instrument
2) Click Connect in(PICTURE6.1) to automatically diagnose the current type and get
CAS identification information (Attention: record the CAS ID)
3) Click Key Learn->>>CAS Learn to enter key learn interface in (PICTURE6.1)
4) In (PICTURE6.1), click Get Key Info read CAS immo data, key cutting code and CAS
remote frequency. (Remember: when you get window (PICTURE 6.3-1), you need choose
Add Key)
Attention: The key info can read directly if CAS isn’t ISTAP version. If CAS belongs
to ISTAP version, there will prompt update CAS flash when the first time read key
info(PICTURE6.5-1). Upgrade CAS flash only need 10 minutes, after update flash
turn to next step. If the update CAS failed by some reasons, you can fix it with
the function in Menu->Special Function->CAS Repair（EEPROMOBDII）, choose
type“OBDII-CAS3+ISTAP Version” , CAS Repair with OBD ->Enter CAS ID to
repair. Detail can be found in chapter 10 CAS Repair
To Next Page
Loading...