(PICTURE7.2-1)
(PICTURE7.2-2) is the window after load CAS1 EEPROM dump (CAS2, CAS3 is
same). Key ID show “FFFFFFFF” means this position not use, and show with other
values mean there already have a key. Select a key position, put a blank7936 chip or
Hitag2 (PCF7942-7944, PCF7945, PCF7946, PCF7953) chip, prepare dealer key
accord to prompt and save new EEPROM dump. About the write new dump file
back you can refer chapter 6.1 about write back new dump after make key for
CAS1/CAS2/CAS3/CAS3+
(PICTURE7.2-2)
To Next Page
Loading...