INFORMATION
Safety information
Read the safety information carefully and look at the device to familiarise yourself with it before you
attempt to install, operate or service it.
WARNING
Electrical danger!
The Wallbox must be installed, commissioned and serviced by appropriately trained,
qualified and authorised electricians
(1)
who bear full responsibility for compliance with
current standards and installation regulations.
Please note that an additional overvoltage protector may be required by vehicles or national
regulations.
Please refer to your national connection and installation standards.
Before commissioning, check that all screw and clamp connections are tight!
The terminal panel must never be left open without supervision. Fit the terminal panel
cover when you leave the Wallbox.
Do not make any unauthorised changes or modifications to the Wallbox.
Repair work to the Wallbox is not permitted, and may be completed only by the
manufacturer or a trained expert (Wallbox replacement).
Do not remove any identifiers such as safety symbols, warning instructions, rating plates,
labels or cable markings.
The Wallbox does not have a main switch. The RCCB and circuit breaker for the building
installation can be used as power cut-off device.
Make sure that the charging cable is not mechanically damaged (kinked, jammed or run
over) and that the contact area does not come into contact with heat sources, dirt, or water.
Do not put your fingers into the connector.
Always conduct a visual inspection for signs of damage before charging. Pay particular
attention to dirt and moisture on the charging plug, cuts on the charging cable or chafing
on the insulation, and also ensure that the cable output from the Wallbox is securely
fastened.
(1)
People who, as a result of the training, skills and experience and knowledge of the relevant standards
can assess the work and identify possible dangers.
IMPORTANT
Never clean the Wallbox using a jet of water (hosepipe, pressure washer, etc.)!
Ensure that the Wallbox is not damaged by incorrect handling (housing cover, internal parts,
etc.).
If it is raining or snowing and the Wallbox is installed outdoors, do not open the terminal
panel cover.
Protect the charging plug from dirt and water with the dust cap when not in use.
Risk of breakage of the plastic housing!
- No countersunk screws may be used for mounting!
- Do not use force to tighten the fastening screws.
- The mounting surface must be completely flat (max. 1 mm difference between the
support or attachment points). Deflection of the housing must be avoided.
EN
9
To Next Page
Loading...
