Name: BobsCNC QUANTUM MINI
Brand: BobsCNC
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Step 4 Routing the X1 and X2 Stepper Motor Wire to the

Controller Support.

Step 4a Take the DuPont Connector for the X1 Stepper

Motor (right side when view from the back)

and run it up and through the hole in the

upper Gantry Cross Brace then through the

hole in the Gantry Side Assembly as shown.

Questions and Answers:

Need help?

Do you have a question about the BobsCNC QUANTUM MINI and is the answer not in the manual?

BobsCNC QUANTUM MINI Specifications

General