BOCI BLT441 - 1. Product Description; 1.1 Product View; 1.2 Technical Parameters; 1.3 LED Indicator Meanings

BLT441 Product Manual
Table of contents
BLT441 Product Manual ...........................................................................1
1. Product Description ............................................................................. 1
1.1 Product View .................................................................................................................................................... 1
1.2 Technical parameters ......................................................................................................................................2
1.3 Meaning of LED indicator ................................................................................................................................ 3
2. Gas port ...............................................................................................4
3. Water cooling interface ....................................................................... 5
4. Electrical interface ...............................................................................6
4.1 Bus system ....................................................................................................................................................... 7
4.2 Non-bus systems ............................................................................................................................................. 8
5. Cutting head installation ..................................................................... 9
5.1 Preparation before operation ......................................................................................................................... 9
5.2 Specific operation process ............................................................................................................................ 10
5.2.1 Preparation of clean bench .................................................................................................................10
5.2.2 The cutting head is placed in the clean workbench ........................................................................... 10
5.2.3 Clean and wipe the fiber interface of the cutting head ......................................................................11
5.2.4 Check the laser fiber end face .............................................................................................................11
5.2.5 Tear off the protective film/remove the protective cap ..................................................................... 11
5.2.6 Insert the laser fiber interface into the cutting head ..........................................................................12
5.2.7 Winding seal ........................................................................................................................................ 12
5.2.8 Mount the cutting head on the backplane ..........................................................................................13
5.2.9 Installing the ceramic body and nozzle ..............................................................................................14
BOCI