BLT441 Product Manual
5
3. Water cooling interface
Installation connection: water-cooled water inlet port 2A, water-cooled water outlet port 1A
Notice:
Deionized/distilled water (conductivity < 10 μ S/cm) specified by the laser manufacturer is
recommended.
Recommended cooling water setting value: cooling water pressure ≤5bar (0.5Mpa), water flow rate ≥
2.0l/min.
Please refer to the dew point table to set the cooling water temperature to prevent condensation on
the optical components.
Dew point temperature at different temperature and humidity
Water cooling water
To Next Page
Loading...