Bodet BOXPRO - Equipment Configuration; Retrieving Network Settings; Update Procedure

21
4. Equipment configuration
4.1 Retrieving network settings
It is possible to retrieve the BOXPRO network settings, such as:
- IP address,
- Subnet mask,
- MAC address.
To retrieve this information:
Insert a USB key (without any rmware for the BOXPRO) into the BOXPRO.
Wait a few moments and watch the LED on the front panel, indicating that the settings le has been
deposited on the USB key.
Refer to chapter 5.1 LED behaviour.
Remove the USB key from the BOXPRO.
Open the «Boxpro_informations.txt» le located on the USB key from a PC.
4.2 Update procedure
To proceed with the BOXPRO update:
Contact our sales department to obtain the updated rmware.
Access the BOXPRO conguration site (General settings page)
Refer to chapters 3. Equipment conguration and 3.3.3 General settings page.
On the General settings page, click on the
Update BoxPro
button, a window opens.
Click on then select the rmware le from the Windows explorer.
Once the rmware has been imported, click on
Start update
.
Wait while the rmware is being installed and watch the behaviour of the LED on the front panel.
Refer to chapter 5.1 LED behaviour.
When the LED stops ashing, the installation is complete.
Complete the installation by clicking on “Reload page”.
As a reminder:
In order to work, the rmware versions of the SCOREPAD main keyboard and
the BOXPRO must be identical.
EN