Need help?Do you have a question about the Bodet SIGMA H and is the answer not in the manual?
General| Synchronization | NTP |
|---|---|
| Mounting | Wall-mounted |
| Material | Metal |
| Power supply | 24V DC |
| Communication | Ethernet |
| Operating temperature | +50°C |
Details electrical protections required for 110-230V, 24V DC, and 36-72V DC SIGMA versions.
Describes the normal operation display, showing time, date, and radio signal status.
Explains accessing the user menu and lists options like USB transfer, DHF receivers, and time settings.
Guides on loading programs into the SIGMA and backing up its configuration via a USB key.
Steps for setting the SIGMA to DHF initialisation mode to add new clocks.
Instructions for setting, removing, or managing the SIGMA's access code.
How to adjust the SIGMA's time, date, and select time zones, including DST.
How to check the quality of radio signal reception and its impact on time synchronization.
Guide to choosing the desired display language from the available options.
How to access and view the current software version of the SIGMA master clock.
How to configure time synchronization modes like FI/DCF, GPS, or manual.
Details how to set automatic dates for summer and winter time transitions.
Allows manual adjustment of time base drift when no external synchronization is active.
Configuration of impulse, D1D2, Afnor, and DHF time outputs.
Defines the SIGMA's role (master/slave) and controls screen backlight behavior.
Instructions for updating the SIGMA's operating software using a USB drive.
Procedure to reset the SIGMA to its original factory configuration.
Guidance on physically installing the SIGMA unit on a wall or within a rack.
Details on connecting power, signal lines, and synchronization inputs.
Step-by-step guide for setting up the 24V impulse clock output.
Instructions for connecting and configuring the DHF transmitter output.
How to connect and configure the 24V TBT output on the SIGMA.
To Next Page
