EasyManua.ls Logo

Bodet Profil 930 - User Manual

Bodet Profil 930
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
B.P. 30001
49340 TRÉMENTINES
FRANCE
Tél. : +33 241 71 72 00
Fax : +33 241 71 72 01
www.bodet-time.com
Upon receipt, always check the product for damage during shipment. If any is found, you may le a damage
claim with the carrier.
Réf.: 605751 X
Clocks
Prol 930-940
Prol TGV 930-940
Prol 930 metal
Independent QUARTZ on battery
IRIG B/AFNOR - DHF time signal
reception
Receiver Minute, ½ minute, Second
impulses
Radio synchronisation on battery
INSTALLATION AND OPERATING INSTRUCTIONS

Other manuals for Bodet Profil 930

Question and Answer IconNeed help?

Do you have a question about the Bodet Profil 930 and is the answer not in the manual?

Summary

Initial Verification

Unpacking the clock

Instructions for unpacking the clock and checking the package contents, including the manual and accessories.

Installation

Single Face indoor clock

Steps for installing an indoor clock, including screw placement and connections.

Single Face outdoor clock

Procedure for mounting an outdoor clock, including cable routing and wall bracket fitting.

Power Supply

Setting

What to Do If... Check

The clock (powered by battery) had stopped

Troubleshooting steps for a stopped battery-powered clock, including battery replacement and contact cleaning.

No synchronisation after the installation

Checks for synchronisation issues, including signal type and programming compatibility.

AFNOR; Irig-B receiver stopped at 12 h00

Troubleshooting for AFNOR/Irig-B receivers stopped at 12h00, checking for impulse loss.

DHF clock stopped at 12 h00

Diagnosing DHF clocks stopped at 12h00, checking for time messages and battery status.

Switch again a DHF clock to initialisation mode

Procedure to re-initialize a DHF clock by shunting pins, saving configuration to EEPROM.

Summary

Initial Verification

Unpacking the clock

Instructions for unpacking the clock and checking the package contents, including the manual and accessories.

Installation

Single Face indoor clock

Steps for installing an indoor clock, including screw placement and connections.

Single Face outdoor clock

Procedure for mounting an outdoor clock, including cable routing and wall bracket fitting.

Power Supply

Setting

What to Do If... Check

The clock (powered by battery) had stopped

Troubleshooting steps for a stopped battery-powered clock, including battery replacement and contact cleaning.

No synchronisation after the installation

Checks for synchronisation issues, including signal type and programming compatibility.

AFNOR; Irig-B receiver stopped at 12 h00

Troubleshooting for AFNOR/Irig-B receivers stopped at 12h00, checking for impulse loss.

DHF clock stopped at 12 h00

Diagnosing DHF clocks stopped at 12h00, checking for time messages and battery status.

Switch again a DHF clock to initialisation mode

Procedure to re-initialize a DHF clock by shunting pins, saving configuration to EEPROM.

Bodet Profil 930 Specifications

General IconGeneral
DisplayLED
MaterialAluminum
SynchronizationNTP
Power Supply230V AC, 50/60Hz
MountingWall mounted
Operating Temperature0° to +50°C

Related product manuals