SEE NOTE 1:
A. Apply weight stack numbers to weight stack Top Plate (8) and each Weight Stack Plate
as shown.
SEE NOTE 2: Note the shape of each shroud for proper placement.
B. Weight Stack Shroud (CA) is pre-assembled with Shroud Insert (CB).
Attach Weight Stack Shroud (CA) to the side of the weight stack as shown.
Bolt onto Side Base Frame (B) and Top Pulley Frame (K) using:
Two 87 (3/8” x 5/8” round allen head)
Two 98 (3/8” washer)
C. Attach Weight Stack Shroud (CC) to the other side of this weight stack using:
Two 87 (3/8” x 5/8” round allen head)
Two 98 (3/8” washer)
D. Weight Stack Shroud (CD) is pre-assembled with Shroud Insert (CE).
Attach Weight Stack Shroud (CD) to the side of the weight stack as shown.
Bolt onto Main Base Frame (A) and Top Pulley Frame (K) Using:
Two 87 (3/8” x 5/8” round allen head)
Two 98 (3/8” washer)
E. Attach Weight Stack Shroud (CF) to the other side of this weight stack using:
Two 87 (3/8” x 5/8” round allen head)
Two 98 (3/8” washer)
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
STEP
22
52
To Next Page
Loading...
