Bofan PT600X - Set FMS server and tracker port by SMS; Set Time Interval by SMS

11
000000APN<APN data>, <User name>, <Password>
4.2.4 Set FMS server and tracker port by SMS
SMS Command format : <password> SVR<FMS domain>, <Port>
Example: Sending SMS command 000000SVRDEMO.LIVEGTS.COM,8600 to set the FMS domain and tracker
port number.
PT600X will reply with an SMS ―SET OK, IP: DEMO.LIVEGTS.COM,8600‖.
Note: Please use your FMS complete domain name in capital in SVR command, DEMO.LIVEGTS.COM just for
example at here. PT600X’s port number always is 8600.
4.2.5 Set Time Interval by SMS
It is for automatically update tracker position in FMS
SMS Command format : <password>GTI<time seconds>
SMS Example: Sending SMS command 000000GTI30 to set the time interval.
PT600X will reply with a SMS ―Set GPRS Time Interval=30 OK‖.
Note:
 If you want to save GPRS cost for SIM card in tracker
You can set the tracker using longer time interval when vehicle ignition is off. In this case, please connect
the PT600X’s input4 to vehicle ignition wire, and send SMS command 000000GTI30,0,0,0,240 to tracker,
and then PT600X will update position to FMS very 30 seconds when vehicle ignition is ON, and every 2
hours when vehicle ignition is OFF (30seconds x 240=7200seconds=2hours).
 If your vehicle often runs on the curve road, for get better route display in FMS
You can set the tracker update position at each corner, the complete command for better route and saving
GPRS cost is 000000GTI30,0,30,0,240 to tracker, you also need to connect the PT600X’s input4 to vehicle
ignition wire, the tracker will update position to FMS once the vehicle turns bend for 30 degree or over 30
degree, and also update position very 30 seconds when vehicle ignition is ON, every 2 hours when vehicle
ignition is OFF (30secondsx240=7200seconds=2hours).
Note: Refer above 4.2.2 ~ 4.2.5 steps commands, also can be set via debug tool on your PC, please refer to
―BOFAN Device Online Configuration User Manual‖