Bofan PT600X - SMS Commands List; Get current location; Two-way communication; Extending use of two-way communication

16
 First you need to set Speed Alarm (both are ok by SMS or in FMS)
 Second sending two SMS commands 000000AN1'#OPC2,1,',10,'#OPC2,0' and
000000SALSPD10001 to tracker.
Note: the fifth parameter in SALSPD is for the AN command number, AN1  1 at fifth parameter, AN2  2
at fifth parameter, parameter 1
st
to 4
th
details, please refer to command list.
 Wired Door Sensor: once two parts away from each other, it will send you key2 alarm, you can
rename this key2alarm to ―door open alarm‖ in system config in FMS.
 RFID sets: it can be used for driver identification and students & school bus management, more
details please refer to RFID user manual.
 About Fuel Sensor, Temperature Sensor and Alcohol Sensor operation details, please refer to its
own separate user manual.
6. SMS Commands List
Note: the device password is 000000 as default
Get tracker firmware version
Command
<password>VER
Remarks
VER=Version
Get current location
Command
<password>RCP
Remarks
Get current location’s latitude and longitude of PT600X
Two-way communication
Command
<password>TEL
Remarks
PT600X SIM card will call your mobile phone after you send the command, once you answer the
phone, two way communication begins
NOTE
Please install speaker and microphone on PT600X before using this function
Extending use of two-way communication
Command
<password>TEM2
Remarks
If you want to save credit of SIM card number in PT600X, you can send this command, then dial out
from your mobile phone to PT600X’s SIM card number for two way communication
Voice Monitoring
Command
<password>TEN
Remarks
PT600X SIM card will call your mobile after you send the command to PT600X, you can answer
this call and start to listen the voice around microphone
NOTE
Please install microphone on PT600X before you use this function
Extending use of Voice Monitoring