BOGE Operating instructions for C 15 series screw compressors Page 59
Maintenance 6.3 Maintenance work compressor
– Remove oil drainage hose and replace blind plug with new copper seal.
– Remove the cap nut from the solenoid valve.
– Change oil filter (procedure as described above).
– Change oil separators (procedure as described above).
Filling with new oil:
– Fill up to the edge of the thread of the filling socket (max.) (procedure as
described above).
– Conduct trial run.
– Check the oil filters and oil separators for leaks and tighten by hand, if nec-
essary.
– Check oil level (procedure as described above).
Top up oil losses, if any.
Flushing the oil circuit
Flushing the oil circuit with clean oil becomes necessary:
– When the oil is excessively soiled.
– Prior to changing the oil type.
WARNING!
Always fill with the same oil type as previously used. Never mix different oil
types and brands.
The oil circuit must be flushed prior to changing the oil type.
WARNING: Risk of injury!
Prior to checking tightness and oil level again take all necessary safety pre-
cautions described on page 44!
WARNING!
Detailed information as to the flushing with BOGE oils you can obtain from
the following service numbers:
Telephone: +1-770-874-1570
Telephone: +49 5206 601-140
WARNING: Risk of injury!
Prior to any maintenance and servicing work take all necessary safety pre-
cautions described on page 44!
To Next Page
Loading...
Need help?
General
