To Next PageTo Next Page
Need help?Do you have a question about the Boge DS2 Series and is the answer not in the manual?
Keep manual for entire machine life.
Symbols indicating danger or damage to equipment.
Operate with closed panels; use disconnecting switch.
Risks not eliminated in design stage.
Keep unit upright, protected from elements and impacts.
Use suitable forklift, avoid impacts during movement.
Check unit condition upon receiving; report any damage.
Store packed unit in a clean, dry place.
Install unit indoors, protected from direct atmospheric agents.
Ensure 1.5m clearance around the unit.
Avoid pollutants; consider ducting for specific versions.
Connect using approved cable and circuit breaker.
Connect unit to a suitable draining system.
Verify installation, valve status, and power supply.
Start the dryer before the air compressor.
Operate continuously during compressor working period.
Stop the dryer 2 minutes after the compressor stops.
Optional thermostat for high dew point signal.
Disconnect power, use original parts, handle leaks properly.
Handle refrigerant safely; warranty implications.
Schedule of checks for efficiency and reliability.
Recover refrigerant and oil according to regulations.
General