Name: Boge EO Series
Brand: Boge
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Default Chapter5
- Table of Contents5
Who Are These Operating Instructions Aimed at9
Content of These Instructions9
Other Important Documents10
Guide for Reading10
- Symbols and Typographic Aids10
- Structure of Warning Notices11
Warranty and Service12
- Limitation of Liability12
- Transport Damage12
- Service12
- Data on the Rating Plate13
System Subject to Monitoring13
General Safety Information15
- Intended Use15
- Reasonably Foreseeable Misuse15
- Responsibility of the Operator16
- Personnel Requirements17
- Special Warning Notices18
Safety Information for Operating the Compressor19
- Electrical Equipment of the Compressor20
- Scroll Compressor, Drive, Air System21
- Lubricant and Refrigerant22
Servicing Safety Information22
- Safety Information for Maintenance and Repair of the Dryer (EO23
How the Compressor Works25
- Compression Process25
- Cooling Air Requirement26
Control of the Compressor27
- Net Pressure27
- Operating States27
- Operating Modes27
Safety and Monitoring Devices27
- General27
- Emergency Stop Function / Main Switch (Mains Disconnecting Device)28
- Temperature Monitoring28
- Decompression28
Technical Data30
How the DS Dryer Works34
- DS Refrigerant Dryer34
How the DRL 6-2 Dryer Works35
- Device Overview35
- Functional Principle of the DRL 6-236
Regulating the DRL 6-2 Integrated Dryer36
- Compressed Air Side36
- Refrigerant Side36
- Pressure Dew Point Regulation37
- Condensate Drainage37
4.1 Transporting the Compressor39
Part 4: Transporting the Compressor39
- General39
- Intermediate Storage of the Compressor before Installation39
- Part 4: 4.1 Transporting the Compressor39
- Transporting the Compressor Using a Forklift Truck40
- Transporting the Compressor with a Crane40
Installing the Compressor41
- Specifications for the Compressor Room41
- Checking the Scope of the Delivery44
- Positioning the Compressor44
- Removing the Transport Locks44
- Belt Tension44
- Installation Conditions for Compressed Air Receivers45
- Installation Conditions for DRL 6-2 and DS Dryers45
Assembly Work46
- General46
Establishing the Connections46
- Connecting the Compressor to the Compressed Air Network48
- 1Establishing the Electrical Connection48
- Condensate Outlet Connection (EO49
Commissioning the Compressor51
- Checking the Installation Conditions51
- Checking the Pressure Settings52
- Checking the Rotation Direction of the Drive and Fan Motors52
- Checking the Leak Tightness of the Compressed Air Pipes53
- Opening the Shut-Off Valves53
- Conducting a Test Run53
Shutting down / Recommissioning the Compressor54
- Shutting down the Compressor for Prolonged Periods54
- Recommissioning the Compressor after a Prolonged Period of Inactivity54
- Refrigerant Compressed Air Dryer54
Operating the DRL 6-2 DL Dryer55
Basic Information on Servicing57
- Servicing Safety Information57
- Servicing by BOGE Customer Service Recommended60
- Servicing Overviews60
- Maintenance Intervals64
- Maintenance Work between Fixed Servicing Intervals64
- Maintenance Work at Fixed Servicing Intervals65
- Maintenance Work on the Dryer (EO66
- General Information on Lubricants and Refrigerants66
- Disposing of Used Operating Materials and Condensates67
- Pressure Hoses67
- Spare and Wearing Parts67
Performing Maintenance Work between Fixed Servicing Intervals68
- Monthly: Check / Replace Supply Air Filter for Switch Cabinet Ventilation68
- Monthly: Checking / Cleaning the Suction Filter68
- Every 1,500 Operating Hours: Cleaning the Cooler69
- Every 5,000 or 10,000 Operating Hours: Cleaning the Fan71
Having Maintenance Work Performed at Fixed Servicing Intervals73
- Every 3,000 Operating Hours: Changing the Suction Filter Cartridge73
- Every 3,000 Operating Hours / Annually: Function Check of the Safety Valves73
- Every 3,000 Operating Hours / Annually: Checking the V-Belts74
- Every 3,000 Operating Hours / Annually: Checking the Non-Return Valves74
- Scroll Compressor Servicing74
- Every 10,000 Operating Hours: Replacing the V-Belts74
- Replacing the Scroll Compressor76
Special Maintenance Work76
- Drive Motors with Permanent Lubrication76
Maintenance Work on the DRL DL Dryer 6-276
- Daily Checks76
- Weekly Maintenance76
- Annual Maintenance76
- Every 15,000 / 20,000 Operating Hours Replacing the Scroll Compressor76
Disposal after Dismantling or Replacement of Parts77
Spare Parts and Additional Equipment78
- List of Spare and Wearing Parts (for Maintenance)78
- Spare Parts for the DRL 6-2 DL Dryer78
- Spare Parts for the DS Dryer78
- List of Available Additional Equipment78
Basic Information on Remedying Faults79
- Part 7: 7.1 Basic Information on Remedying Faults79
- Compressor Faults80
- Refrigerant Dryer and Treatment Faults (EO81
8.2 Application of the Pressure Equipment Directive83
Appendix Application of the Pressure Equipment Directive83
- Scope83
- Part 8: 8.1 Guidelines and Standards83
- Classification and Assessment of Pressurised Components84
- Outcome of the Assessment84
- Installation in Compressed Air Systems84
Guidelines and Standards83
Pneumatic Circuit Diagrams84
- Pneumatic Circuit Diagram for EO 6, Air-Cooled85
- Pneumatic Circuit Diagram for EO 6 D, Air-Cooled86
- Pneumatic Circuit Diagram for EO 6 R, Air-Cooled87
- Pneumatic Circuit Diagram for EO 6 DR, Air-Cooled88
- Pneumatic Circuit Diagram for EO 6 TR, Air-Cooled89
- Pneumatic Circuit Diagram for EO 11 (D), Air-Cooled90
- Pneumatic Circuit Diagram for EO 16, Air-Cooled91
- Pneumatic Circuit Diagram for EO 17 (D), Air-Cooled92
- Pneumatic Circuit Diagram for EO 22 (D), Air-Cooled93
List of Maintenance Work Performed94

Brand	Boge
Model	EO Series
Category	Air Compressor
Language	English

Boge EO Series User Manual

Table of Contents

Questions and Answers:

Boge EO Series Specifications

Related product manuals