Maintenance every 6 months
BOMAG
47
BPR 35/40 D BPR 35/60 D
5.15 Check, adjust the valve
clearance
!
Caution
The engines are equipped with an automatic
valve clearance adjustment, the valve clear-
ance does therefore not need to be checked
and adjusted.
5.16 Cleaning cooling fins and
cooling air intake opening
i
Note
Dirty operating conditions, especially lubrication
oil and fuel deposits on the cooling fins of the cyl-
inder and in the cooling air intake reduce the cool-
ing power. You should therefore immediately seal
any leaks in the area of the fuel tank, the cylinder
or the cooling air intake and clean the cooling fins
after.
Dry dirt
Fig. 54
l Dry clean the entire cooling air area like cylin-
der head, cylinder flywheel blower and blow it
out with compressed air (Fig. 54).
Wet or oily dirt
!
Danger
Fire hazard!
Do not use any inflammable solvents.
!
Caution
Do not spray directly on electric assemblies
and plug connectors or dry them with com-
pressed air immediately after.
Find the cause of oily dirt and have leaks
sealed by the after sales service of BOMAG.
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
