BT50/BT60/BT65BOMAG8
Do not touch the piston with the cleaning tools.
Working on the tamper foot
Wipe off spilled oil, catch running out oil and
dispose of environmentally.
Store oily material in a specially marked container
and dispose of environmentally.
Cleaning
Do not clean the machine while the engine is
running.
Do not use gasoline or other inflammable sub-
stances to clean the machine.
When using steam cleaning equipment do not
subject electric parts and insulating material to the
direct water jet or cover them beforehand.
Do not guide the water jet directly into the air filter,
into the exhaust or into the air intake opening.
After the maintenance work
Reinstall all protective devices after completing
maintenance.
Repair
Repairs must only be carried out by qualified and
authorized personnel. Always follow our repair
instructions.
Exhaust gases are highly dangerous! Always en-
sure an adequate supply of fresh air when starting
in closed rooms!
Attach a warning tag to the steering bow if the
machine is defective.
•
Do not mix the nozzle in the carburettor up by
mistake.
•
Adjust the idling speed regulator screw exactly.
•
Do not damage the blower wheel when working
on the magnetic ignition.
•
Always replace selflocking nuts.
•
Do not open the foot cover on the tamper foot,
spring tension. Danger of accident!
•
Observe the prescribed tightening torques.
Safety regulations
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
