Bomag BT 65 - Checking Tamper Foot Oil Level

BT50/BT60/BT65 BOMAG 23
4.6 Tamper foot plate
Fig. 1
•
Retighten the screws (Fig. 1).
4.7 Checking the oil level in the
tamper foot
Stand the tamper on level ground and let it rest
for while, to allow all oil to run down into the
housing.
Fig. 2
•
Clean the inspection glass (Fig. 2).
•
Check the oil level, it must reach the middle of
the inspection glass. Top up oil if necessary.
For quality of oil refer to the paragraph on
fuels and lubricants.
Maintenance every month
Go to Discount-Equipment.com to order your parts