BT50/BT60/BT65BOMAG10
3.1 Tests before commissioning
During the running-in period the engine idling
speed may be higher than normal, because of the
good movability of the engine parts
In this case read just the idling speed on the
carburettor, refer to the respective chapter.
The running-in period for the vibratory tamper is
10 operating hours.
Check
•
Condition of engine and machine
•
Fuel tank and fuel lines for leaks
•
Fuel level
•
Bellows for damage and leaks
•
Oil filling in the tamper cylinder
•
Visual inspection of the machine
3.2 Filling in fuel
Fire hazard!
Only fill in fuel with the engine shut down and
the fuel valve closed. Do not spill any fuel!
Do not inhale any fuel fumes.
No fire, do not smoke!
Mixing ratio with two-stroke engine oil 50:1
Fig. 1
Fuel:
Unleaded standard grade gasoline (Fig. 1).
Oil:
Use only two-stroke engine oil, whereby the oil
may also have self-mixing abilities. Unsuitable oil
causes premature oil carbon deposits in the outlet
manifold of the engine.
Operation
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
