BOON EDAM THT-100 - Page 39

THT-100 38
Boon Edam Inc.
402 McKinney Parkway Version: Rev A6 10/28//2011
Tel. 910-814-3800 fax 910-814-3899 Issue: THT-100-IMM-USA
Electrical
• Check the safety functions of unit (speed control, heel guards etc., if equipped).
• Perform a function test, ACS controls.
• Check the operation of the solenoids.
• Check earth grounding.
• Check the electrical wiring connections, especially for damage near moving parts.
Mechanical
• Check the anchor mountings and fasten where needed.
• Check the movement of bottom bearing and mounting anchors. Lubricate bearing
through grease zerk.
• Check the whole installation for correct alignment with floor (surroundings)
• Inspect locking pawls for wear. Ensure they properly lock and hold.
• Inspect Key override functions
• Inspect Fire Alarm functions (if connected)
• Inspect Power failure functions
• Inspect Dampening system (if equipped) to ensure rotor arms rotate and rest smoothly.