EN
45
Operation
www.bora.com
User menu overview
Menu item/Description/Selection area Factory
setting
1 Volume of the acoustic signals (0-9) 4
2 Childproofing feature (On/Off) Off
3 Show and reset filter status
4 Duration of the automatic after-run function
(10, 15, 20 min)
20 min
5 Touch zone reaction speed
(1 slow, 2 medium, 3 fast)
2
6 LED test
7 Permanent pan size recognition Off
8 Software/hardware version
9 Safety shut-down (1 long, 2 medium, 3 short) 2
A Super simple mode Off
0 Reset to factory settings
Tab. 7.4 User menu overview
7.6.1 Menu item 1:
Volume of the acoustic signals
INFO In the event of an error message the acoustic
signal is always heard at full volume and cannot
be changed.
INFO The acoustic signal when switching on or off is
always set to at least volume level 4.
INFO The current set volume is shown in the rear, left-
hand cooking zone display when the menu item is
called up.
Fig. 7.2 Menu item 1: Volume of the acoustic signals
Setting the acoustic signal volume:
Swipe
upwards or downwards until the required
volume is reached.
Move to another menu item or close the menu.
long press on the cooking zone with an active timer
The timer is switched off.
The system switches to the standard display.
The cooking zone remains active on the set power
level.
Time lapsed
10 seconds before the set time lapses, the system
flashes the remaining time.
In the last 5 seconds of the countdown an acoustic
signal can be heard every second.
The time display
and the timer button flash.
After the end of the set time the cooking zone is
automatically deactivated (= power level
).
7.5.10 Switching off the cooking zone
Tap the required cooking zone.
Swipe right down to the bottom until
appears in the
cooking zone indicator
or
long press on the cooking zone
is displayed in the cooking zone display.
After 2 seconds, the standard display appears.
or
tap until
appears in the cooking zone indicator.
7.6 User menu
Certain functions can be set in the user menu.
INFO Below you will find explanations on how to use
the menu and a description of the most important
menu items.
INFO The menu can only be called up if all cooking
zones and the cooktop extractor are inactive. In
addition, there must be no residual heat.
Calling up the user menu
Switch on the device by pressing the power button
.
If start-up is successful, the standard display will
appear in the operating panel.
Long press on the multi-function display.
The menu is called up and the first menu item is
displayed.
Closing the user menu
Long press on the multi-function display
The menu is closed and the standard display appears.
Navigating the user menu
Tap the multi-function display
The system moves to the next menu item.
The system automatically adopts and saves set values
when you move to another menu item or close the
menu.
To Next Page
Loading...
Need help?
General
