LTC 2600 Series | Instruction Manual | Multiplexer Read (MR) Commands
Bosch Security Systems | July 12, 2004
EN
|
30
MR-CAM-AUTOCOLOR
This command returns the setting for the multiplexer
autocolor operation.
Parameter values for <auto-detect> are:
0 Disables Autocolor
1 Enables Autocolor
MR-CAM-COLOR
This command returns a 16-bit table value indicating
the settings for color operation of the cameras
connected to the system.
The <table 16> parameter ranges in value from <0> to
<65535> (decimal) OR <0> to <FFFF> (hex) where
the value in each table position corresponds to the
color operation of a specific camera (i.e. a value of 1
indicates enabled color; a value of 0 is disabled color
operation).
MR-CAM-FULL <monitor>
This command returns the camera number (displayed
in full screen) assigned to the specified monitor.
NOTE: If the monitor is not in full screen mode, the
command has no effect.
Parameter values for <monitor> and <camera#> are:
<monitor> 1 Monitor A
2Monitor B
<camera#> 1 to 16
MR-CAM-NUMBER
This command returns the starting camera number to
be displayed on the monitor when the camera
connected to rear panel camera input #1 is selected.
Parameter values for <starting-number> range from
<1> to <983>.
MR-CAM-TITLE <camera#>
This command returns the camera title for the
specified camera number.
Parameter values for <camera#>:
<camera#> 1 to 16
MR-CAM-VIDEOLOSS-MESS <table 16>
This command returns a 16-bit table value for the
videoloss message status of individual cameras.
The <table 16> parameter ranges in value from <0> to
<65535> (decimal) OR <0> to <FFFF> (hex) where
the value in each table position corresponds to the
video loss message status of a specific camera (i.e. a
value of 1 indicates enabled video loss messages; a
value of 0 is disabled video loss messages).
MR-DISPLAY-MODE <monitor>
This command returns the display mode for the
specified monitor.
Parameter values for <monitor> and <display-mode>
are:
<monitor> 1 Monitor A
2Monitor B
<display-mode> 0 Full Screen
1 Single Quad
73 x 3 Multi
84 + 3 Multi
912 + 1 Multi
10 4 x 4 Multi
11 8 + 2 Multi
NOTE: This command also returns a <screen-
number> value which for quad modes represents the
quad mode number.
MR-FREEZE <monitor> <cameo#>
This command returns the freeze function setting for
the specified cameo on the specified monitor.
NOTE: If the specified monitor is in full screen mode,
the cameo specification is redundant (i.e. unnecessary).
Parameter values for <monitor>, <cameo#> and
<boolean> are:
<monitor> 1 Monitor A
9 Monitor B
<cameo#> 1 to 16
<boolean> 0 Disable
1 Enable
To Next Page
Loading...
