ACS 553, ACS 563 Service Manual
1 689 975 295 2021-04-13 Robert Bosch GmbH
16
Introduction
and to remove water from refrigerant. To meet
The unit gives a warning when (SEE TABLE) of
down when the
(
been reached and will no longer function.
1. Call up the Main Menu.
2. Select icon.
3. Select icon.
4. Select from the
Maintenance Menu or when the machine
prompts. The machine displays:
REMAINING FILTER CAPACITY: XXX.XYY
REPLACE FILTER NOW?
• The machine displays amount of filter
capacity remaining until the machine
locks down. This message may occur at
maintenance action.
5. Select
icon to resume using the machine.
1. If icon
ENTER NEW FILTER SERIAL NUMBER
If SERIAL NUMBER WRONG is
displayed, the serial number has been incorrectly
machine.
2. Use the keypad to enter the serial number
icon to continue.
•
displays:
TURN POWER OFF
AND REPLACE FILTER
3.
4. Remove the old filter (1) by turning it
counterclockwise. Refer to Figure 1-4.
1
5.
are lubricated and correctly located in the
grooves as shown in Figure 1-5.
6. Install the new filter by threading it
clockwise into place. Verify the filter is
positioned correctly. Tighten the filter to
20 Nm ± 1.
7. Switch on the machine.
Machine starts with vacuum pump oil
change (Refer to the “Vacuum Pump
Maintenance” in this section).
9.
the machine according to the laws in your
jurisdiction.
.
Model
R134a
(alert 56 kg)
Model
R1234yf
O-rings
To Next Page
Loading...
