ACS 553, ACS 563 Service Manual
1 689 975 295 2021-04-13 Robert Bosch GmbH
20
Introduction
For the magnet installation, refer to Figure 1-10.
1. Plug the magnet (1) within the housing
underneath the machine base.
“Calibration check” in this section.
1
For the conversion kit installation follow
instructions hereby:
1. Call up the Main Menu.
2. Select icon.
3. Select icon.
4. Select " and
enter password then select icon.
5. Select and select
icon to start the function.
second recovery machine with same refrigerant
and suitable free capacity.
6.
display. Turn on the recovery unit and select
icon.
7. Start the recovery function from the recovery
unit.
In case of recovery machine without
deep-recovery capabilities, perform vacuum for
Disconnect the recovery machine and
connect hoses as indicated at display.
9. Select icon to start the vacuum function.
step “Convert unit refrigerant” only if previous
“AC unit emptying” has been completed
successfully.
To Next Page
Loading...
