AMC2 Modular
Controller
Operating | en 53
Bosch Access Systems GmbH 2018-09 | AMC2-4W_UL |
The selected display mode remains set until the next time the
button is pressed. The order of the display pages is shown in
the following table.
Push Display (Example) Description
0 V01.00 02.03.07
or
LBUS or BG900
Software versions and date of
the firmware - every 5 sec.
alternating with the display of
the reader interface.
1a S/N1: 0910019212 BOSCH serial number
1b S/N2: 00000001
2 02.06 15:35:15 (S) Current date and time
(S) = Summer; (W) = Winter
3 Dig. IO: :::::::::::::::: Display of the digital contacts:
the input signals set will be
shown with an extension above
- output signals with an
extension below.
3a Dig. I1: :::::::::::::::: If there are I/O-Boards
connected the signals will be
shown on separate pages.
3b Dig. I2: ::::::::::::::::
3c Dig. I3: ::::::::::::::::
4 MAC 0010174C8A0C Network device address (MAC)
5 N AMC-1234-5678 Network name of the AMC2
6 I 192.168.10.18 IP-address of the AMC2
7 G 192.168.10.255 IP-address of the gateway
(Version V 00.44 or higher)
8 M 255.255.255.0 Subnetmask
(Version V 00.44 or higher)
To Next Page
Loading...
