Bosch B420 - User Manual

1
2017
B426/B420 Conettix Ethernet
Communication Module: Setup &
Troubleshooting Guide

Summary

IP Communicator Component Overview

Bus Type, Address Selection and Function

Maintenance and troubleshooting LEDs

Maintenance and troubleshooting LEDs (continued)

How to connect to RPS using the IP Communicator

How to connect to RPS using: Connect Via: IP Direct:

Local connection from B-Series or GV4 panels to RPS via Ethernet.

How to connect to RPS using Connect Via: Network:

How to configure the IP Communicator using keypad programming.

When using B920 or B930 SDI2 type Keypads:

Step-by-step guide for configuring the IP communicator via keypad.

When using D1255 or D1260 SDI type keypads:

Instructions for configuring the IP communicator via keypad for D1255/D1260.

How to configure the IP Communicator using Remote Programming Software.

How to configure the IP Communicator using the Web Browser.

Basic Network Settings Page

Advanced Network Settings Page

Panel Address Settings Page

Encryption and Security Settings Page

Encryption Enable

How to enable encryption and set AES key size/string.

Web and Automation Security

Security settings for web interface and communications.

Maintenance Page

Factory Default Page

Firmware Upgrade Page

Connect to the Web Interface when the IP address is Unknown

Troubleshooting

Trouble connecting the IP Communicator to the Web Interface

Steps to resolve issues connecting to the IP communicator's web interface.

Applications with the IP communicator set to DHCP;Auto-Enable=YES

Applications with the IP communicator set to DHCP;Auto-Enable=NO

The IP Communicator settings in RPS are greyed out or keypad programming is locked

Trouble connecting to RPS using the IP Communicator

Verify RPS Panel Account Type and Firmware Revision

Verify Correct Module Address Selection

Check for Address Conflicts

Verify the correct RPS passcode is used when connecting.

B-Panels or GV4 Version 2+ using B920;B930 Keypad

GV4 Version 1.00-1.99 using an SDI Keypad

GV3 Version 8.10+ using an SDI Keypad

Trouble connecting to RPS: Connect via: IP Direct.

Verify PC and IP Communicator DHCP Usage

Verify DHCP Settings using SDI Keypad (D1255;D1260)

Verify DHCP Settings using B920;B930 Keypad

Trouble connecting when using Connect via: Network

For SDI2 Connections

For SDI or Option Bus connections

Verify Correct Encryption Settings

Bosch B420 Specifications

General

Directivity	Cardioid
Impedance	200 Ohms
Compatibility	Bosch Conference System
Microphone Type	Condenser
Connection Type	Wired
Cable Length	2 m