3
The IP Communicator settings in RPS are greyed out or keypad programming is locked ................... 19
Trouble connecting to RPS using the IP Communicator ............................................................................ 20
Verify correct panel account type selected in RPS for existing panel firmware revision. .................. 20
Verify correct module address selection. .................................................................................................. 20
Check for address conflicts. ........................................................................................................................ 20
Verify the correct RPS passcode is used when connecting. .................................................................. 21
Trouble connecting to RPS: ‘Connect via: IP Direct’. .............................................................................. 22
Trouble connecting when using Connect via: Network ........................................................................... 23
Verify correct Encryption settings (G or Non-G thru GV4 v1.00-1.99 types only). ............................. 23
To Next Page
Loading...
