6 en | Introduction Conettix Ethernet Communication Module
2016.08 | 08 | F.01U.266.226 Installation and Operation Guide Bosch Security Systems, Inc.
2.3 Installation workflow
To install and configure the module, use the workflow below. Follow in sequential order from
top to bottom. Check off each box as you complete a step.
Caution!
Always power down the control panel when connecting a module. To power down the control
panel, unplug the transformer and disconnect the battery.
Plan the installation. Refer to System overview, page 7.
Set the address switch. Refer to Bus address settings, page 9.
Install the module. Refer to Mount the module in the enclosure, page 10, Mount and wire
the tamper switch (optional), page 10, and Wire to the control panel, page 10.
Configure the module. Refer to Plug and Play configuration for SDI2 or option bus control
panels, page 13, or Plug and Play configuration for SDI or option bus control panels, page 13,
or Web-based configuration, page 13.
Verify operation using the LEDs. Refer to Maintenance and troubleshooting LEDs, page 30.
To Next Page
Loading...
