Commands
You can initiate functions with the [CMD] key plus the one or two
digit command.
If you know the command number, press the [CMD] key and then
the one or two digit command.
Notice!
After you press [CMD], you can use /[PREV] or /
[NEXT] to move through the list of commands, and
press [ENTER] when viewing the desired command.
Review the available commands in the following table.
Control Panels B94x/B93x menu tree and commands | en 51
Bosch Security Systems, Inc. 2015.01 | 02 | F.01U.307.371
To Next Page
Loading...
