17
Note: There is a 5 degree deadband required between
heating and cooling setpoints to prevent equipment from
short cycling.
3. If you want to add more periods, then click add period
button and repeat the above 3 steps until you have set all
your periods for the day.
Note: You are allowed a maximum of 8 periods per day.
4. If you want to delete a period, select any bubble
corresponding to that period and click Delete.
5. After you have set up one day of the week, use the Copy
section to mirror the same daily schedule to other days of
the week by clicking on the days you would like to copy that
daily set of periods. Then click next.
Note: If you have not copied your schedule to all 7 days of
the week, you will be required to repeat the above steps until
you have set a schedule for everyday of the week.
On Device
During offline operations, only 2 schedules (Home and
Vacation) are available. However, when a Wi-Fi connection is
established, the list can be expanded up to 4 schedules.
Home
You can use this schedule to set your heating/cooling
equipment to predefined set points. The device initially comes
with a factory default schedule, which can be adjusted as
necessary.
Vacation
This schedule will be used to set your heating/cooling
equipment to 2 periods with set points (1 heating and 1
cooling) that can be manually adjusted. However, you will not
be able to add additional or remove current periods. The
schedule can be used for vacation or permanently setting a
heating/cooling set point.
To Next Page
Loading...
Need help?
General
