123
Group adjustment
Next, select an input pin for the trigger channel
And create a channel name for the trigger channel
C 60 Online Measurement
Internal | BEG/EMS1 CsM
| 6/4/2010 | ©
Bosch Engineering GmbH 2009. All rights reserved, also regarding any disposal, exploitation,
reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Motorsport
C 60 Online Measurement + Calibration
Note: If a low-active signal is
selected as an input channel, do not
forget to enable the pull-up resistor
for the pin. Otherwise the group
adjustment will be triggered
periodically
To Next Page
Loading...
