Product Information
Condens 7000 FP – 6721846699 (2022/12)
6
2.5 Accessories
Refer to the Technical product brochure for a complete overview of all
available accessories.
The following accessories are available from your local sales office:
• Water treatment accessories for initial filling and feeding
• Pressure relief valve or safety assembly
• Flue system
• Air supply system
•Control unit
• Cascade pipework (on the water and flue gas side for dual cascades)
2.6 Tools, materials and assembly aids
The following tools and assembly aids are required for commissioning,
inspection and maintenance of the boiler:
• Standard tools used by heating system installers and for gas and
water installations
• Metric hexagon wrench set (7; 8; 10; 13 width across flats)
• Allen key set (4 mm)
•Torx key set
• The control unit as a monitoring device for commissioning,
inspection and maintenance of the boiler.
The following may also prove useful:
• 2 transport rollers (furniture transport rollers; load-bearing capacity
> 300 kg, height >150 mm) for rolling the boiler.
– Alternative: 5 pipes (approx. R 1¼ ", approx. 700 mm long) as
base for rolling the floor standing boiler.
• Cleaning blade and/or chemical cleaning agent for wet cleaning
(available as accessories).
2.7 The heating system is operated and monitored via
App or Web Portal
We offer, in combination with the relevant control unit, a comprehensive
range of products for monitoring, diagnosis and control of the floor
standing boiler via mobile terminal devices, PC or tablet.
2.8 Product overview
The GC7000FP is a floor standing condensing boiler with an aluminium
heat exchanger.
2.8.1 Product description
The main components of the Condens 7000 FP are:
• Control unit
•Boiler block
• Device frame and casing
•Gas burner
The control unit monitors and controls all electrical components of the
floor standing boiler.
The boiler block transfers the heat generated by the burner to the
heating water. The thermal insulation reduces the radiation and standby
losses.
The control unit enables the basic operation of the heating system. It
provides the following functions, among others, for that purpose:
• Turning the heating system on/off
• Setting the DHW temperature and maximum boiler temperature in
heating mode
• Status display
The control unit CC83xx or MX25 must be mounted at the designated
position on the boiler.
It is forbidden to extend the data line and mount the control unit outside
the boiler.
Many additional functions that enhance control and operating
convenience as well as providing information on the heating system
settings are described in the relevant technical documentation of the
installed control unit.
To Next Page
Loading...
Need help?
General