Transporting the boiler
Condens 7000 FP – 6721846699 (2022/12)
14
Loosen the 2 securing screws on the holding plate of the burner base,
do not remove them (Fig. 10, [1]).
Fig. 10 Screws on the burner base
[1] 2 securing screws
[2] 4 screws on the holding plate
[3] Gasket in the carriage
With the help of a second person, lift the burner base slightly and
unhook from the securing screws. In doing so, observe the gas supply
pipe protruding to the top and the cable.
Put down the burner base and protect against pollution and damage.
Fig. 11 Remove the burner base
Installing the burner
NOTICE
Property damage from trapping cables and gaskets!
During installation, the cable hanging down and gaskets not inserted
correctly may be damaged.
During installation, take care that the cable cannot be trapped and is
routed back in its original position.
Take care that the gaskets are mounted correctly (Fig. 10 and
10).
Hang the burner base in the securing screws and screw tight. In doing
so, observe the gas supply pipe protruding to the top and the cable.
Loosen the gas pipe on the gas valve. For this purpose, remove the 4
screws on the flange (Fig. 48).
Pull the burner base back until the end position (O-ring on the guide
pins).
Install the mixture manifold with burner rod (Chapter 11.12.4,
page 50)
Installing the gas pipe on the gas valve.
Reconnect electrical connections.
Check for tightness after installation.
4.2 Transporting the boiler by crane
WARNING
Property damage and personal injury up until danger to life from
incorrect transport with a crane!
Incorrect transporting with a crane may damage the appliance and / or
lead to life-threatening injuries when falling down.
Use only transport ropes that are in a flawless state.
Hooks may only be attached to the crane lifting eyes intended for this
purpose.
Secure the load against falling.
Do not walk under the suspended load.
When transporting, a second person must assist for securing and
stabilising.
Remove the front and rear wooden crate (do not remove the upper
wooden frame)
Check the screws of the transport timber for a secure seat.
0010041670-002
1
2
3
To Next Page
Loading...
